The Prime L20 Trail Camera provides the following connections for external devices: USB port and SD card slot (Fig. 65-2164B. A 3-way power switch is used to select the main operating modes: OFF, AIM, and ON (Fig. Bushnell. As shown in Fig. Press and hold the enter button until the camera switches to the 5 digit password mode. This interval allows time for you to close the Prime L20 Trail Camerasfront cover, lock it, and leave the monitored area. We recommend mounting the Prime L20 Trail Camera on a sturdy tree with a diameter of about 6 in. Press OK and use UP/DOWN to set the hour (24 hr/military time format). Try to set your camera up in an area where there is not a heat source in the camera's line of sight. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: The device does not contain any user-serviceable parts. The Prime L20 Trail Camera will take photos or videos automatically (according to its current parameter settings) when it is triggered by the PIR sensors detection of activity in the area it covers.You can either move the power switch directly from OFF to ON mode or stop at the AIM position first to change one or more settings, then move the switch to ON after you have finished doing so.AIM MODEIn the AIM mode, you can check and change the settings of the Prime Trail Camera with the help of its built-in LCD. Make sure that the camera has good batteries in it. To take out the SD card, just gently push in the card (do not try to pull it out without pushing in first). Try different distances and angles from the camera. If you are only using a single camera to monitor an area, simply leave it set to the default Id: 01. I have had one of these cameras since last season. It can be triggered by any movement of the game in a location, detected by a highly sensitive Passive Infra-Red (PIR) motion sensor, and then take high-quality pictures (up to 20MP still photos), or 720p HD video clips. For the best experience on our site, be sure to turn on J The Prime L20 Trail Camera consumes very little power (less than 0.08 mA) in a stand-by (surveillance) state. According to the manual, the motion detector LED is supposed to flash in "setup" mode and for up to . Reviewing Images Directly From the SD CardThis is the most popular method of viewing images. Model: 90202. Use UP/ DOWN to select 5 sec (display shows 00:05), 15 sec (default value), 30 sec, 1 min (display shows 01:00) or 5 min. Please contact Bushnell customer service.7. If you would rather leave your camera in the woods and just pull its SD card out, an SD card reader works the same way as described in this section once the card is inserted and the reader is connected to your computer.